Model: Stainless Steel Inline Pump
Chugger Pumps are the next generation beer pump for homebrewers. Designed and built by fellow homebrewers these pumps provide an excellent addition to any brew setup. These low velocity pumps are magnetic driven and therefore should not be run dry. They will require the pump head and lines to be full before the pump is started.
Some features specific to Chugger Pumps are:
-
Full Ported Inlet (1/2”) which will prevent cavitation problems
-
3/16” Polished End
-
120th Horsepower which makes the motor run significantly quieter
-
Easy assembly/disassembly - 4 Phillips Head screws hold both front housing and back housing
-
Rear casing contains a 2 7/8” diameter impeller which is designed to increase head pressure to 17’/head
-
O-Ring is made of a clear silicone to prevent contamination from dyes in your brew
-
Ridge is built into the casing to securely hold o-ring and prevent sealing problems
-
7-8 Gallon flow per minute makes Chugger Pumps one of the industry’s top performers!
-
All features detailed above cover both the Stainless Steel & Polysulfone Plastic models
-
Designed and manufactured by actual homebrewers with a clear understanding of the needs of a brewer
Additional information and pump technical specifications may be be found in the additional information tab.
Inlet 1/2" MPT Outlet 1/2"MPT
316 STAINLESS STEEL (Front Housing), 316 Stainless Steel (Rear Housing), Teflon (Thrust Washer), CLEAR Silicone (O-Ring), POLYSULFONE (Impeller)
Max Flow 7 GPM 22.7 LPM
Max Head 18.6 FT 4.1 M
Power .04 HP .029 KW
Electrical 115V 50/60HZ
Submersible Non-Submersible
60HZ 50HZ
Max Flow 7 GPM 22.7 LPM
Max Head 18.6 FT 4.1 M
Power .04 HP .029 KW
Electrical 115V 50/60HZ
Submersible Non-Submersible
60HZ 50HZ
Max Flow 7.3 GPM
Max Head 18.9 FT
Power .05 HP
Can handle liquids of 250F
Materials are FDA Food Compliant
Components are UL Recognized
Do not run dry.